Skid Mounted Nitrogen Gas Generator for Pharmacutical, Oil Well is an advanced gas separation technology. It uses high-quality imported carbon molecular sieve as adsorbent and adopts the principle of pressure swing adsorption at room temperature to separate air to produce high-purity nitrogen.
As a common instrument and equipment, Skid Mounted Nitrogen Gas Generator for Pharmacutical, Oil Well is unavoidable to have failures. It is very important to eliminate and check the problems in normal operation. So what are the possible failures of Skid Mounted Nitrogen Gas Generator for Pharmacutical, Oil Well?

1. There is a sound during the operation of the nitrogen generator:
Countermeasures: Use a wrench to properly adjust the tightness of the nut on the solenoid valve, not too tight; if not, you need to disassemble the solenoid valve to clean the interior (the noise is mainly due to impurities in the solenoid valve), if the cleaning does not work, it must be replaced new.
2. When the nitrogen generator is turned on, there is gas output:
Countermeasures: When the pressure rises just after starting the machine, you need to press the delay switch. Then continue to use it 10 minutes after the output pressure is released from the output end.
3. Skid Mounted Nitrogen Gas Generator for Pharmacutical, Oil Well cannot work when it is turned on, and the display panel has no display:
Countermeasures: firstly check whether the power supply is good, whether the plug is inserted properly, and then check whether the insurance is in good condition, and whether the cable plug-in of the instrument display board is properly inserted.
4. The nitrogen output from Skid Mounted Nitrogen Gas Generator for Pharmacutical, Oil Well is impure:
Countermeasures: Check whether the electrolyte concentration is too low, and whether the difference between the air pressure of the nitrogen generator and the air source pressure is too small.