1. The normal supply and normal opening and closing of the power supply, gas source, and temperature conditions required by the nitrogen generator; especially the stability of the power supply voltage, reduce the damage to the controller and solenoid valve caused by the power supply problem.
2. Malaysia Psa Nitrogen Generator and Nitrogen Plant for Industry stated that the pressure of the air storage tank should be paid attention to at any time, and the pressure of the air storage tank should be kept between 0.6 and 0.8 MPa, not lower than the rated value.
3. Malaysia Psa Nitrogen Generator and Nitrogen Plant for Industry said that the automatic drain should be checked daily to avoid blockage and loss of drainage. If it is blocked, open the manual valve slightly, close the self-draining valve, and then remove the automatic drain to disassemble and clean. When cleaning the auto drain, just use a soapy lather.

4. Malaysia Psa Nitrogen Generator and Nitrogen Plant for Industry reminded to regularly check the three pressure gauges on the nitrogen generator, make a daily record of their pressure changes for equipment failure analysis, and observe the flowmeter and nitrogen purity at any time, which have been maintained. The nitrogen purity of the outgassing.
5. Regularly check the refrigeration effect of the air dryer every week, so as to avoid the failure of the air dryer and the inflow of water into the nitrogen generator and the occurrence of carbon molecular sieve poisoning.
6. Malaysia Psa Nitrogen Generator and Nitrogen Plant for Industry remind that operation and daily maintenance should be carried out according to the requirements of the instrument use code, and the sensitivity of the solenoid valve/pneumatic valve, the pressure range of the pressure regulating valve, the accuracy of the gas analyzer, The compression of the adsorption tower, the exhaust status of the muffler, the cleanliness of the inner tube of the flowmeter, etc.